|
|
|
@ -43,7 +43,7 @@ is not directly connected to the 3.3V Vin of the ESP32 chip, making it a |
|
|
|
less than optimal candidate for powering the board during flashing. Instead, |
|
|
|
powering the lamp using its own power supply works best. |
|
|
|
|
|
|
|
 |
|
|
|
 |
|
|
|
|
|
|
|
You can use some sticky tape to fixate the cables before soldering. |
|
|
|
|
|
|
|
@ -70,7 +70,7 @@ to find another way to attach GPIO0 to ground. Some options: |
|
|
|
|
|
|
|
- Use a breadbord, so you can connect the USB Adapter GND pin to a row on |
|
|
|
the bread bord, and connect the GND and GPIO0 wires of the board to that |
|
|
|
same row. |
|
|
|
same row. |
|
|
|
|
|
|
|
- Solder a button on the board that connects GPIO0 to GND when pressed. Then |
|
|
|
you can hold down this button while plugging in the device's power supply. |
|
|
|
@ -89,7 +89,7 @@ to find another way to attach GPIO0 to ground. Some options: |
|
|
|
- You could opt for temporarily soldering a lead between GND and GPIO0 on |
|
|
|
the board, making GPIO0 pulled to ground permanently. It is a bit less |
|
|
|
flexible than some other options, but if you only need to do the initial |
|
|
|
backup and firmware flash of the device, then this can bee all that you |
|
|
|
backup and firmware flash of the device, then this can bee all that you |
|
|
|
need. Remove the lead after flashing is done, otherwise the device won't |
|
|
|
boot in normal mode. |
|
|
|
|
|
|
|
@ -143,7 +143,7 @@ Compile the firmware for the device and download the `firmware.bin` file |
|
|
|
to the device to which the serial adapter is connected. |
|
|
|
|
|
|
|
You can flash the device using esphome or esptool. |
|
|
|
I normally use the [esphome-flasher](https://github.com/esphome/esphome-flasher) |
|
|
|
I normally use the [esphome-flasher](https://github.com/esphome/esphome-flasher) |
|
|
|
tool, which is a very easy to use GUI utility app for flashing ESPHome devices: |
|
|
|
|
|
|
|
- In the app, select the COM port of your serial adapter |
|
|
|
|
Maurice Makaay
