diff --git a/doc/flashing.md b/doc/flashing.md index d59fd77..80f5ca2 100644 --- a/doc/flashing.md +++ b/doc/flashing.md @@ -71,6 +71,8 @@ adapter. In this example, I have used male wires, so I could plug them into a br Solder the wires to the `RX`, `TX`, `GND` and `GPIO0` debug pads. +Beware not to use too much solder on the GPIO0 pad, because that might flow onto the pad that is right +next to it, permanently putting the device in flash mode as a result. *Note: The board has a debug pad that exposes 3.3V. Do not use this pad to power the board from your serial adapter. Always power the lamp using its own power supply.*