From a3d0f1c29e570d66cb357293e3da305e8a6e5c92 Mon Sep 17 00:00:00 2001 From: Maurice Makaay Date: Mon, 13 Jun 2022 22:37:24 +0200 Subject: [PATCH] Add warning about GPIO0 pad soldering --- doc/flashing.md | 2 ++ 1 file changed, 2 insertions(+) diff --git a/doc/flashing.md b/doc/flashing.md index d59fd77..80f5ca2 100644 --- a/doc/flashing.md +++ b/doc/flashing.md @@ -71,6 +71,8 @@ adapter. In this example, I have used male wires, so I could plug them into a br Solder the wires to the `RX`, `TX`, `GND` and `GPIO0` debug pads. +Beware not to use too much solder on the GPIO0 pad, because that might flow onto the pad that is right +next to it, permanently putting the device in flash mode as a result. *Note: The board has a debug pad that exposes 3.3V. Do not use this pad to power the board from your serial adapter. Always power the lamp using its own power supply.*