substitutions:
  name: bedside_lamp
  friendly_name: Bedside Lamp
  transition_length: 1s

# Use your own preferences for these components.

wifi:
  #ssid: "Your-SSID"
  #password: "Your-Password"
  #use_address: 192.168.10.12
  #
  # Enable fallback hotspot (captive portal) in case wifi connection fails
  #ap:
  #  ssid: "Bedside_lamp_$name"
  #  password: "bedside2021"

captive_portal:
api:
ota:
logger:

# Special platform + package are used for enabling unicore and disabling the
# efuse mac crc check. These two changes are required for the ESP32-WROOM-32D
# that is used in the Yeelight bedside lamp 2.
esphome:
  name: $name
  platform: ESP32
  board: esp32doit-devkit-v1
  platformio_options:
    platform: espressif32@3.2.0
    platform_packages: |-4
          framework-arduinoespressif32 @ https://github.com/pauln/arduino-esp32.git#solo-no-mac-crc/1.0.6

# NOTE: HIGHLY OPTIONAL BLOCK
#
# This yeelight_bs2 comopnent acts as the hub for the device. Other
# components talk to the hardware via this component. Normally, you
# wouldn't need to change anything in the default implementation. You
# can even fully omit this element from the configuration.
# Only define this when you need different pin numbers or want to
# assign specific ID's to the pin components.
yeelight_bs2:
  red_id: TheRedOne
  red: GPIO13
  green_id: TheGreenOne
  green: GPIO14
  blue_id: TheBlueOne
  blue: GPIO5
  white_id: TheWhiteOne
  white: GPIO12
  master1_id: TheFirstMaster
  master1: GPIO33
  master2_id: TheSecondMaster
  master2: GPIO4
  sda: GPIO21
  scl: GPIO19
  trigger_pin: GPIO16

# This component controls the light of the device.
light:
  - platform: yeelight_bs2
    name: ${friendly_name} RGBW Light
    default_transition_length: ${transition_length}
    # You can use any effects that you like. These are just examples.
    effects:
      - random:
          name: "Slow Random"
          transition_length: 30s
          update_interval: 30s
      - random:
          name: "Fast Random"
          transition_length: 3s
          update_interval: 3s

# The binary sensor is used to handle front panel touch events.
binary_sensor:
  - platform: yeelight_bs2
    id: ${name}_power_button
    part: power button
    on_press:
      then:
        - light.toggle: ${name}

# The sensor is used to publish a slider level when the slider is touched.
sensor:
  - platform: yeelight_bs2
    id: ${name}_slider_level
    on_value:
      then:
        - light.turn_on:
            id: ${name}
            brightness: !lambda return x;