# ESPHome components for Xiaomi Mijia Bedside Lamp 2 The Bedside Lamp 2 is a smart RGBWW LED lamp, produced by Yeelight. It can be controlled via the WiFi network and using a touch panel on the front of the device. The touch panel contains a power button, a button that changes the color of the light and a slider that can be used to change the brightness of the light. This project provides custom components for ESPHome, which make it possible to fully control every aspect of the lamp and to integrate the lamp in your Home Assistant setup. ## Quick start guide For those who have experience with flashing ESPHome onto devices: * Clone the [GitHub repo](https://github.com/mmakaay/esphome-xiaomi_bslamp2) into your ESPHome `config/custom_components` directory. * Copy `[doc/example.yaml](doc/example.yaml)` to `config/your_device_name.yaml`. * Modify the configuration to your needs (see the [configuration guide](doc/configuration.md)]). * Compile the `firmware.bin` file and download it to the device to which you have connected your serial to USB adapter (FTDI). * Open up the lamp and connect its `TX`, `RX`, `GND` and `GPIO0` debug pads to the serial adapter (see the [installation guide](doc/installation.md) for the debug pad locations). * Power up the lamp with `GPIO0` connected to GND to enable flashing mode. * Flash `firmware.bin` onto the device. If you experience regular disconnects between Home Assistant and the lamp, then take a look at the [known issues document](doc/known_issues.md). ## Table of contents * [Why custom firmware?](doc/why_custom_firmware.md) * [Installation guide](doc/installation.md) * [Configuration_guide](doc/configuration.md) * [Flashing guide](doc/flashing.md) * [Known issues](doc/known_issues.md) * [Sponsoring](doc/sponsoring.md)