You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
68 lines
2.0 KiB
68 lines
2.0 KiB
substitutions:
|
|
name: bedside_lamp
|
|
friendly_name: Bedside Lamp
|
|
transition_length: 1s
|
|
|
|
# Use your own preferences for these components.
|
|
|
|
wifi:
|
|
#ssid: "Your-SSID"
|
|
#password: "Your-Password"
|
|
#use_address: 192.168.10.12
|
|
#
|
|
# Enable fallback hotspot (captive portal) in case wifi connection fails
|
|
#ap:
|
|
# ssid: "Bedside_lamp_$name"
|
|
# password: "bedside2021"
|
|
|
|
captive_portal:
|
|
api:
|
|
ota:
|
|
logger:
|
|
|
|
# Special platform + package are used for enabling unicore and disabling the
|
|
# efuse mac crc check. These two changes are required for the ESP32-WROOM-32D
|
|
# that is used in the Yeelight bedside lamp 2.
|
|
esphome:
|
|
name: $name
|
|
platform: ESP32
|
|
board: esp32doit-devkit-v1
|
|
platformio_options:
|
|
platform: espressif32@1.11.0
|
|
platform_packages: |-4
|
|
framework-arduinoespressif32 @ https://github.com/pauln/arduino-esp32.git#solo-no-mac-crc/1.0.4
|
|
|
|
light:
|
|
- platform: yeelight_bs2
|
|
name: ${friendly_name} RGBW Light
|
|
default_transition_length: ${transition_length}
|
|
# You can use any effects that you like. These are just examples.
|
|
effects:
|
|
- random:
|
|
name: "Slow Random"
|
|
transition_length: 30s
|
|
update_interval: 30s
|
|
- random:
|
|
name: "Fast Random"
|
|
transition_length: 3s
|
|
update_interval: 3s
|
|
|
|
# The device uses two I2C busses.
|
|
i2c:
|
|
# This bus is very likely connected to an EEPROM that can be found
|
|
# on the lamp's board, right next to the GND, TX, RX and GPIO0 debug
|
|
# pads. The exact use of this component has not yet been reverse
|
|
# engineered.
|
|
- id: eeprom_i2c
|
|
sda: GPIO17
|
|
scl: GPIO18
|
|
scan: True
|
|
# This bus is connected to the front panel with the touch buttons.
|
|
# The touch panel is fully separated form the main board and ESP32,
|
|
# and communication is done strictly through I2C. The exact protocol
|
|
# has been reverse engineered and can be found in the file
|
|
# "doc/reverse_engineering/I2C protocol/i2c_commands.txt".
|
|
- id: front_panel_i2c
|
|
sda: GPIO21
|
|
scl: GPIO19
|
|
scan: True
|