Fork of the espurna firmware for `mhsw` switches
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

23 lines
465 B

providers: relays, lights and buttons refactoring (#2414) - gpio module now tracks the known providers (right now, hardware and mcp expander) - refactored relay struct to use 'Provider' implementing setup,notify,change,boot instead of just BasePin actions - refactored button module to use gpio provider instead of referencing types itself - removed dual & stm code from buttons, migrate both to relay module - added status notify and change callbacks for relayStatus (i.e. 'notify' when relay status was called, but not changed. and 'changed' when it did) - relays runtime configuration keys - relay command now shows configured relays and current & target statuses - refactor the code using relayStatus(0, blah) under LIGHT_PROVIDER check to use lightState instead - remove rfbridge code form relay module. implement through a basic state listener in the rfbridge module, depend on RELAY_SUPPORT - allow to bind rf codes to real relays - drop tuya-specific lights provider, remove tuya code from relays and lights modules - integrate tuya via relay listeners and providers, use lights custom provider - implement channel transitions for tuya. disabled by default, and transition time and step are overridden to 2000 + 100. needs to be set to some value below the total time (i.e. `total transition time / step time == number of steps`, we need to figure out a correct time that serial comms could handle) - lights custom provider (global, not per-pin) and state listeners - remove lights code from relay module. implement through providers & listeners in the lights module, depend on RELAY_SUPPORT - lights per-channel relay provider (unused atm), depend on RELAY_SUPPORT - refactored channel transition - calculate step only once, make sure time + step values are sane, generate quick transitions with very small delay (10ms hardcoded) for transitions during OFF state i.e. we no longer waste 500ms (or whatever transition time is set to) on boot doing nothing - transition time + step parameter for the lightUpdate - report mask parameter for the lightUpdate - minor fixes across the board resolve #2222
3 years ago
  1. // -----------------------------------------------------------------------------
  2. // TUYA
  3. // -----------------------------------------------------------------------------
  4. #pragma once
  5. #include "espurna.h"
  6. namespace tuya {
  7. #if LIGHT_PROVIDER != LIGHT_PROVIDER_NONE
  8. void setupChannels();
  9. void sendChannel(unsigned char, unsigned int);
  10. #endif
  11. #if RELAY_SUPPORT
  12. void setupSwitches();
  13. void sendSwitch(unsigned char, bool);
  14. #endif
  15. void setup();
  16. } // namespace tuya