|
|
- //--------------------------------------------------------------------------------
- // These settings are normally provided by PlatformIO
- // Uncomment the appropiate line(s) to build from the Arduino IDE
- //--------------------------------------------------------------------------------
-
- //--------------------------------------------------------------------------------
- // General
- //--------------------------------------------------------------------------------
-
- #ifndef DEBUG_PORT
- #define DEBUG_PORT Serial
- #endif
-
- // Uncomment and configure these lines to enable remote debug via udpDebug
- // To receive the message son the destination computer use nc:
- // nc -ul 8111
-
- //#define DEBUG_UDP_IP IPAddress(192, 168, 1, 100)
- //#define DEBUG_UDP_PORT 8111
-
- //--------------------------------------------------------------------------------
- // Hardware
- //--------------------------------------------------------------------------------
-
- //#define D1_RELAYSHIELD
- //#define NODEMCUV2
- //#define SONOFF
- //#define SONOFF_TH
- //#define SLAMPHER
- //#define S20
- //#define SONOFF_TOUCH
- //#define SONOFF_SV
- //#define SONOFF_POW
- //#define SONOFF_DUAL
- //#define SONOFF_4CH
- //#define ESP_RELAY_BOARD
- //#define ECOPLUG
- //#define WIFI_RELAY_NC
- //#define WIFI_RELAY_NO
- //#define MQTT_RELAY
- //#define WIFI_RELAYS_BOARD_KIT
- //#define AI_LIGHT
- //#define LED_CONTROLLER
-
- //--------------------------------------------------------------------------------
- // Features (values below are non-default values)
- //--------------------------------------------------------------------------------
-
- //#define ENABLE_DHT 1
- //#define ENABLE_DS18B20 1
- //#define ENABLE_EMON 1
- //#define ENABLE_HLW8018 1
- //#define ENABLE_RF 1
- //#define ENABLE_FAUXMO 0
- //#define ENABLE_NOFUSS 1
- //#define ENABLE_DOMOTICZ 0
- //#define ENABLE_ANALOG 1
|
