ESP8266 FS-UAP1 Control board (#1925)

Control board for Hoermann UAP1 Garage interface
http://frank-schuetz.de/index.php/fhem/13-hoermann-torantrieb-mit-espeasy-in-fhem-einbinden

code/espurna/config/arduino.h

@@ -34,6 +34,7 @@
 //#define EXS_WIFI_RELAY_V50
 //#define FORNORM_ZLD_34EU
 //#define FOXEL_LIGHTFOX_DUAL
+//#define FS_UAP1
 //#define GBLIFE_RGBW_SOCKET
 //#define GENERIC_8CH
 //#define GENERIC_AG_L4

code/espurna/config/hardware.h

@@ -3875,6 +3875,40 @@
     #define HLW8012_VOLTAGE_R_DOWN      ( 1000 )        // Downstream voltage resistor
     #define HLW8012_INTERRUPT_ON        CHANGE
 
+// -----------------------------------------------------------------------------
+// FS UAP1
+// http://frank-schuetz.de/index.php/fhem/13-hoermann-torantrieb-mit-espeasy-in-fhem-einbinden
+
+#elif defined(FS_UAP1)
+
+    // Info
+    #define MANUFACTURER            "FS"
+    #define DEVICE                  "UAP1"
+
+    // Inputs
+    #define DIGITAL1_PIN            4
+    #define DIGITAL2_PIN            5
+
+    // Relays
+    #define RELAY1_PIN              12
+    #define RELAY2_PIN              13
+    #define RELAY3_PIN              14
+    #define RELAY4_PIN              15
+
+    #define RELAY1_TYPE             RELAY_TYPE_NORMAL
+    #define RELAY2_TYPE             RELAY_TYPE_NORMAL
+    #define RELAY3_TYPE             RELAY_TYPE_NORMAL
+    #define RELAY4_TYPE             RELAY_TYPE_NORMAL
+
+    // LEDs
+    #define LED1_PIN                2
+    #define LED1_PIN_INVERSE        0
+
+    // Disable UART noise
+    #define DEBUG_SERIAL_SUPPORT    0
+
+// -----------------------------------------------------------------------------
+
 // -----------------------------------------------------------------------------
 // TEST boards (do not use!!)
 // -----------------------------------------------------------------------------

code/platformio.ini

@@ -1594,3 +1594,13 @@ board = ${common.board_1m}
 build_flags = ${common.build_flags_1m0m} -DETEKCITY_ESW01_USA
 upload_port = ${common.ota_upload_port}
 upload_flags = ${common.ota_upload_flags}
+
+[env:fs-uap1]
+board = ${common.board_4m}
+build_flags = ${common.build_flags_4m1m} -DFS_UAP1
+
+[env:fs-uap1-ota]
+board = ${common.board_4m}
+build_flags = ${common.build_flags_4m1m} -DFS_UAP1
+upload_port = ${common.ota_upload_port}
+upload_flags = ${common.ota_upload_flags}