This setting defines the behaviour of the main LED in the board.<br/>
When in "WiFi status" it will blink at 1Hz when trying to connect. If successfully connected if will briefly blink every 5 seconds if in STA mode or every second if in AP mode.<br/>
When in "WiFi status" it will blink at 1Hz when trying to connect. If successfully connected it will briefly blink every 5 seconds if in STA mode or every second if in AP mode.<br/>
When in "MQTT managed" mode you will be able to set the LED state sending a message to "<base_topic>/led/0/set" with a payload of 0, 1 or 2 (to toggle it).<br/>
When in "Find me" mode the LED will be ON when all relays are OFF. This is meant to locate switches at night.<br/>
When in "Status" mode the LED will be ON whenever any relay is ON, and OFF otherwise. This is global status notification.<br/>
<divclass="pure-u-1 pure-u-lg-3-4 hint">In Amperes (A). If you are using a pure resistive load like a bulb this will the ratio between the two previous values, i.e. power / voltage. You can also use a current clamp around one fo the power wires to get this value.</div>
<divclass="pure-u-1 pure-u-lg-3-4 hint">In Amperes (A). If you are using a pure resistive load like a bulb, this will be the ratio between the two previous values, i.e. power / voltage. You can also use a current clamp around one of the power wires to get this value.</div>
Lee Marlow
6 years ago