- remove optional RFRAW_SUPPORT
- enable module when RF_SUPPORT=1, optionally enable RCSwitch
- reorder ifdef checks to treat RFB_DIRECT and old RF_SUPPORT the same
- rename RF_PIN to RFB_RX_PIN
- depend on RF_SUPPORT instead of ITEAD_SONOFF_RFBRIDGE
- runtime TX & RX PIN setting

* Add "Enable Thermostat" switch

* Add heater/cooler thermostat mode

1. Add thermostat to the espurna_modules in progmem.h
2. Add thermostat to webui, gulp, html, js.
3. in general.h MQTT_USE_JSON returned to 0 by default and 1 if thermostat enabled.

* Simply print timestamp for supported destinations
* Update ws destination to support 'prefix' sub-key
* Avoid void casting in telnet module

* send all ws config at once on start
* reduce ws json overhead by creating message buffer manually
* use k:[values] instead of k1:value1, k2:value2 etc. for lists

- Heartbeat mode and interval configuration added to WebUI ADMIN page
- New option HEARTBEAT_REPEAT_STATUS: on device startup full heartbeat information and after HEARTBEAT_INTERVAL only STATUS report.
- Enhanced first heartbeat message - on device startup it will send heartbeat after ntpSynced will be true to get device time.

P.S. Code is tested. Web part is not compiled, and not tested. I hope it will work :)

* Fix energy ratio input for pulse meter sensor

* checkout origin/dev -- webui files

* Telnet auth depends on setting

* use same define suffix as WS_

* add to web

* no initial passwd for core

Show alert if no input on #password page
Do not fail with empty password when on #layout
Fix password selector