STATUS

Current configuration

GENERAL

General configuration values

 
This name will identify this device in your network (http://<hostname>.local). For this setting to take effect you should restart the wifi interface clicking the "Reconnect" button.
 
Here you can define what will be the status of the relay after a reboot.
 
Define how the different relays should be synchronized.

SECURITY

Device security settings

 
The administrator password is used to access this web interface (user 'admin'), but also to connect to the device when in AP mode or to flash a new firmware over-the-air (OTA).
 
This is the key you will have to pass with every HTTP request to the API, either to get or write values.

WIFI

You can configure up to 3 different WiFi networks. The device will try to connect in order of signal strength.

First network
Second network
Third network

MQTT

Configure an MQTT broker in your network and you will be able to change the switch status via an MQTT message. Leave the server field empty to disable MQTT.

 
Send a 0 or a 1 as a payload to the provided topic below to switch it on or off. You can also send a 2 to toggle its current state. The switch will also report its current open/close status to the same topic and its IP address, hertbeat, firmware version and file system version to the topic you define plus "/ip", "/heartbeat", "/version" and "/fsversion" respectively.

POWER

Calibrate your power monitor device. Use a pure resistive load and introduce the expected values for active power, current and voltage. Use the nominal values or a multimeter to get the proper numbers. Set any field to 0 to leave the calibration value untouched.

 
If you are using a pure resistive load like a bulb this will be writen on it, otherwise use a socket multimeter to get this value.