Fork of the espurna firmware for `mhsw` switches
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 

56 lines
1.8 KiB

//--------------------------------------------------------------------------------
// These settings are normally provided by PlatformIO
// Uncomment the appropiate line(s) to build from the Arduino IDE
//--------------------------------------------------------------------------------
//--------------------------------------------------------------------------------
// General
//--------------------------------------------------------------------------------
#ifndef DEBUG_PORT
#define DEBUG_PORT Serial
#endif
// Uncomment and configure these lines to enable remote debug via udpDebug
// To receive the message son the destination computer use nc:
// nc -ul 8111
//#define DEBUG_UDP_IP IPAddress(192, 168, 1, 100)
//#define DEBUG_UDP_PORT 8111
//--------------------------------------------------------------------------------
// Hardware
//--------------------------------------------------------------------------------
//#define D1_RELAYSHIELD
//#define NODEMCUV2
//#define SONOFF
//#define SONOFF_TH
//#define SLAMPHER
//#define S20
//#define SONOFF_TOUCH
//#define SONOFF_SV
//#define SONOFF_POW
//#define SONOFF_DUAL
//#define SONOFF_4CH
//#define ESP_RELAY_BOARD
//#define ECOPLUG
//#define WIFI_RELAY_NC
//#define WIFI_RELAY_NO
//#define MQTT_RELAY
//#define WIFI_RELAYS_BOARD_KIT
//#define AI_LIGHT
//#define LED_CONTROLLER
//--------------------------------------------------------------------------------
// Features (values below are non-default values)
//--------------------------------------------------------------------------------
//#define ENABLE_DHT 1
//#define ENABLE_DS18B20 1
//#define ENABLE_EMON 1
//#define ENABLE_HLW8018 1
//#define ENABLE_RF 1
//#define ENABLE_FAUXMO 0
//#define ENABLE_NOFUSS 1
//#define ENABLE_DOMOTICZ 0