|
|
- // Copyright 2021 Nick Brassel (@tzarc)
- // SPDX-License-Identifier: GPL-2.0-or-later
-
- #pragma once
-
- #include "gpio.h"
- #include "qp_internal.h"
-
- ////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
- // Quantum Painter SSD1351 configurables (add to your keyboard's config.h)
-
- #ifndef SSD1351_NUM_DEVICES
- /**
- * @def This controls the maximum number of SSD1351 devices that Quantum Painter can communicate with at any one time.
- * Increasing this number allows for multiple displays to be used.
- */
- # define SSD1351_NUM_DEVICES 1
- #endif
-
- ////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
- // Quantum Painter SSD1351 device factories
-
- #ifdef QUANTUM_PAINTER_SSD1351_SPI_ENABLE
- /**
- * Factory method for an SSD1351 SPI OLED device.
- *
- * @param panel_width[in] the width of the display panel
- * @param panel_height[in] the height of the display panel
- * @param chip_select_pin[in] the GPIO pin used for SPI chip select
- * @param dc_pin[in] the GPIO pin used for D/C control
- * @param reset_pin[in] the GPIO pin used for RST
- * @param spi_divisor[in] the SPI divisor to use when communicating with the display
- * @param spi_mode[in] the SPI mode to use when communicating with the display
- * @return the device handle used with all drawing routines in Quantum Painter
- */
- painter_device_t qp_ssd1351_make_spi_device(uint16_t panel_width, uint16_t panel_height, pin_t chip_select_pin, pin_t dc_pin, pin_t reset_pin, uint16_t spi_divisor, int spi_mode);
- #endif // QUANTUM_PAINTER_SSD1351_SPI_ENABLE
|