|
|
- # # project specific files
- SRC += matrix.c
-
-
- # MCU name
- #MCU = at90usb1287
- MCU = atmega32u4
-
- # Processor frequency.
- # This will define a symbol, F_CPU, in all source code files equal to the
- # processor frequency in Hz. You can then use this symbol in your source code to
- # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
- # automatically to create a 32-bit value in your source code.
- #
- # This will be an integer division of F_USB below, as it is sourced by
- # F_USB after it has run through any CPU prescalers. Note that this value
- # does not *change* the processor frequency - it should merely be updated to
- # reflect the processor speed set externally so that the code can use accurate
- # software delays.
- F_CPU = 16000000
-
-
- #
- # LUFA specific
- #
- # Target architecture (see library "Board Types" documentation).
- ARCH = AVR8
-
- # Input clock frequency.
- # This will define a symbol, F_USB, in all source code files equal to the
- # input clock frequency (before any prescaling is performed) in Hz. This value may
- # differ from F_CPU if prescaling is used on the latter, and is required as the
- # raw input clock is fed directly to the PLL sections of the AVR for high speed
- # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
- # at the end, this will be done automatically to create a 32-bit value in your
- # source code.
- #
- # If no clock division is performed on the input clock inside the AVR (via the
- # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
- F_USB = $(F_CPU)
-
- # Interrupt driven control endpoint task(+60)
- OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
-
- BOOTLOADER = caterina
-
- # Build Options
- # comment out to disable the options.
- #
- #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
- #MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
- POINTING_DEVICE_ENABLE = yes # Generic Pointer, not as big as mouse keys hopefully.
- EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
- CONSOLE_ENABLE = yes # Console for debug(+400)
- COMMAND_ENABLE = yes # Commands for debug and configuration
- CUSTOM_MATRIX = yes # Remote matrix from the wireless bridge
- # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
- # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
- NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
- # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
- # MIDI_ENABLE = YES # MIDI controls
- UNICODE_ENABLE = YES # Unicode
- # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
-
- USB = /dev/ttyACM0
-
- #upload: build
- # $(honeycomb_UPLOAD_COMMAND)
|