cbbrowne
7 years ago
7 changed files with 273 additions and 208 deletions
Split View
Diff Options
-
+0 -71keyboards/clueboard2/Makefile
-
+0 -63keyboards/clueboard2/clueboard2.c
-
+128 -33keyboards/planck/keymaps/jeebak/keymap.c
-
+59 -39keyboards/planck/keymaps/jeebak/readme.md
-
+77 -0quantum/keymap_extras/keymap_russian.h
-
+4 -2quantum/keymap_extras/keymap_unicode_cyrillic.h
-
+5 -0tmk_core/avr.mk
+ 0
- 71
keyboards/clueboard2/Makefile
View File
| @ -1,71 +0,0 @@ | |||
| # MCU name | |||
| #MCU = at90usb1287 | |||
| MCU = atmega32u4 | |||
| # Processor frequency. | |||
| # This will define a symbol, F_CPU, in all source code files equal to the | |||
| # processor frequency in Hz. You can then use this symbol in your source code to | |||
| # calculate timings. Do NOT tack on a 'UL' at the end, this will be done | |||
| # automatically to create a 32-bit value in your source code. | |||
| # | |||
| # This will be an integer division of F_USB below, as it is sourced by | |||
| # F_USB after it has run through any CPU prescalers. Note that this value | |||
| # does not *change* the processor frequency - it should merely be updated to | |||
| # reflect the processor speed set externally so that the code can use accurate | |||
| # software delays. | |||
| F_CPU = 16000000 | |||
| # | |||
| # LUFA specific | |||
| # | |||
| # Target architecture (see library "Board Types" documentation). | |||
| ARCH = AVR8 | |||
| # Input clock frequency. | |||
| # This will define a symbol, F_USB, in all source code files equal to the | |||
| # input clock frequency (before any prescaling is performed) in Hz. This value may | |||
| # differ from F_CPU if prescaling is used on the latter, and is required as the | |||
| # raw input clock is fed directly to the PLL sections of the AVR for high speed | |||
| # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' | |||
| # at the end, this will be done automatically to create a 32-bit value in your | |||
| # source code. | |||
| # | |||
| # If no clock division is performed on the input clock inside the AVR (via the | |||
| # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. | |||
| F_USB = $(F_CPU) | |||
| # Interrupt driven control endpoint task(+60) | |||
| OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT | |||
| # Boot Section Size in *bytes* | |||
| # Teensy halfKay 512 | |||
| # Teensy++ halfKay 1024 | |||
| # Atmel DFU loader 4096 | |||
| # LUFA bootloader 4096 | |||
| # USBaspLoader 2048 | |||
| OPT_DEFS += -DBOOTLOADER_SIZE=4096 | |||
| # Build Options | |||
| # comment out to disable the options. | |||
| # | |||
| BOOTMAGIC_ENABLE ?= yes # Virtual DIP switch configuration(+1000) | |||
| MOUSEKEY_ENABLE ?= no # Mouse keys(+4700) | |||
| EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450) | |||
| CONSOLE_ENABLE ?= yes # Console for debug(+400) | |||
| COMMAND_ENABLE ?= yes # Commands for debug and configuration | |||
| NKRO_ENABLE ?= yes # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work | |||
| RGBLIGHT_ENABLE ?= no # Enable keyboard underlight functionality (+4870) | |||
| BACKLIGHT_ENABLE ?= yes # Enable keyboard backlight functionality (+1150) | |||
| MIDI_ENABLE ?= no # MIDI controls | |||
| AUDIO_ENABLE ?= no | |||
| UNICODE_ENABLE ?= no # Unicode | |||
| BLUETOOTH_ENABLE ?= no # Enable Bluetooth with the Adafruit EZ-Key HID | |||
| ifndef QUANTUM_DIR | |||
| include ../../Makefile | |||
| endif | |||
+ 0
- 63
keyboards/clueboard2/clueboard2.c
View File
| @ -1,63 +0,0 @@ | |||
| #include "clueboard2.h" | |||
| void matrix_init_kb(void) { | |||
| // put your keyboard start-up code here | |||
| // runs once when the firmware starts up | |||
| matrix_init_user(); | |||
| led_init_ports(); | |||
| // JTAG disable for PORT F. write JTD bit twice within four cycles. | |||
| MCUCR |= (1<<JTD); | |||
| MCUCR |= (1<<JTD); | |||
| }; | |||
| void led_init_ports() { | |||
| // * Set our LED pins as output | |||
| DDRB |= (1<<4); | |||
| } | |||
| void led_set_kb(uint8_t usb_led) { | |||
| if (usb_led & (1<<USB_LED_CAPS_LOCK)) { | |||
| // Turn capslock on | |||
| PORTB |= (1<<4); | |||
| } else { | |||
| // Turn capslock off | |||
| PORTB &= ~(1<<4); | |||
| } | |||
| } | |||
| /* Clueboard 2.0 LED locations: | |||
| * | |||
| * Capslock: B4, pull high to turn on | |||
| * LCtrl: Shared with Capslock, DO NOT INSTALL LED'S IN BOTH | |||
| * Page Up: B7, pull high to turn on | |||
| * Escape: D6, pull high to turn on | |||
| * Arrows: D4, pull high to turn on | |||
| */ | |||
| void backlight_init_ports(void) { | |||
| print("init_backlight_pin()\n"); | |||
| // Set our LED pins as output | |||
| DDRD |= (1<<6); // Esc | |||
| DDRB |= (1<<7); // Page Up | |||
| DDRD |= (1<<4); // Arrows | |||
| // Set our LED pins low | |||
| PORTD &= ~(1<<6); // Esc | |||
| PORTB &= ~(1<<7); // Page Up | |||
| PORTD &= ~(1<<4); // Arrows | |||
| } | |||
| void backlight_set(uint8_t level) { | |||
| if ( level == 0 ) { | |||
| // Turn off light | |||
| PORTD |= (1<<6); // Esc | |||
| PORTB |= (1<<7); // Page Up | |||
| PORTD |= (1<<4); // Arrows | |||
| } else { | |||
| // Turn on light | |||
| PORTD &= ~(1<<6); // Esc | |||
| PORTB &= ~(1<<7); // Page Up | |||
| PORTD &= ~(1<<4); // Arrows | |||
| } | |||
| } | |||
+ 128
- 33
keyboards/planck/keymaps/jeebak/keymap.c
View File
+ 59
- 39
keyboards/planck/keymaps/jeebak/readme.md
View File
+ 77
- 0
quantum/keymap_extras/keymap_russian.h
View File
| @ -0,0 +1,77 @@ | |||
| #ifndef KEYMAP_RUSSIAN_H | |||
| #define KEYMAP_RUSSIAN_H | |||
| #include "keymap.h" | |||
| // Normal Chracters // reg SHIFT | |||
| #define RU_A KC_F // а and А | |||
| #define RU_BE KC_COMM // б and Б | |||
| #define RU_VE KC_D // в and В | |||
| #define RU_GHE KC_U // г and Г | |||
| #define RU_DE KC_L // д and Д | |||
| #define RU_IE KC_T // е and Е | |||
| #define RU_IO KC_GRV // ё and Ё | |||
| #define RU_ZHE KC_SCLN // ж and Ж | |||
| #define RU_ZE KC_P // з and З | |||
| #define RU_I KC_B // и and И | |||
| #define RU_SRT_I KC_Q // й and Й | |||
| #define RU_KA KC_R // к and К | |||
| #define RU_EL KC_K // л and Л | |||
| #define RU_EM KC_V // м and М | |||
| #define RU_EN KC_Y // н and Н | |||
| #define RU_O KC_J // о and О | |||
| #define RU_PE KC_G // п and П | |||
| #define RU_ER KC_H // р and Р | |||
| #define RU_ES KC_C // с and С | |||
| #define RU_TE KC_N // т and Т | |||
| #define RU_U KC_E // у and У | |||
| #define RU_EF KC_A // ф and Ф | |||
| #define RU_HA KC_LBRC // х and Х | |||
| #define RU_TSE KC_W // ц and Ц | |||
| #define RU_CHE KC_X // ч and Ч | |||
| #define RU_SHA KC_I // ш and Ш | |||
| #define RU_SHCHA KC_O // щ and Щ | |||
| #define RU_HSIGN KC_RBRC // ъ and Ъ | |||
| #define RU_YERU KC_S // ы and Ы | |||
| #define RU_SSIGN KC_M // ь and Ь | |||
| #define RU_E KC_QUOT // э and Э | |||
| #define RU_YU KC_DOT // ю and Ю | |||
| #define RU_YA KC_Z // я and Я | |||
| #define RU_1 KC_1 // 1 and ! | |||
| #define RU_2 KC_2 // 2 and " | |||
| #define RU_3 KC_3 // 3 and № | |||
| #define RU_4 KC_4 // 4 and ; | |||
| #define RU_5 KC_5 // 5 and % | |||
| #define RU_6 KC_6 // 6 and : | |||
| #define RU_7 KC_7 // 7 and ? | |||
| #define RU_8 KC_8 // 8 and * | |||
| #define RU_9 KC_9 // 9 and ( | |||
| #define RU_0 KC_0 // 0 and ) | |||
| #define RU_MINS KC_MINS // - and _ | |||
| #define RU_EQL KC_EQL // = and + | |||
| #define RU_BSLS KC_BSLS // \ and / | |||
| #define RU_DOT KC_SLSH // . and , | |||
| // Shifted Chracters | |||
| #define RU_EXLM LSFT(RU_1) // ! | |||
| #define RU_DQUT LSFT(RU_2) // " | |||
| #define RU_NMRO LSFT(RU_3) // № | |||
| #define RU_SCLN LSFT(RU_4) // ; | |||
| #define RU_PERC LSFT(RU_5) // % | |||
| #define RU_COLN LSFT(RU_6) // : | |||
| #define RU_QUES LSFT(RU_7) // ? | |||
| #define RU_ASTR LSFT(RU_8) // * | |||
| #define RU_LPRN LSFT(RU_9) // ( | |||
| #define RU_RPRN LSFT(RU_0) // ) | |||
| #define RU_UNDR LSFT(RU_MINS) // _ | |||
| #define RU_PLUS LSFT(RU_EQL) // + | |||
| #define RU_SLSH LSFT(RU_BSLS) // / | |||
| #define RU_COMM LSFT(RU_DOT) // , | |||
| // Alt Gr-ed characters | |||
| #define RU_RUBL RALT(RU_8) // ₽ | |||
| #endif | |||