@ -49,10 +49,6 @@ First you have to compile firmware with the build option `NKRO_ENABLE` in **Make
Try `Magic`**N** command(`LShift+RShift+N` by default) when **NKRO** still doesn't work. You can use this command to toggle between **NKRO** and **6KRO** mode temporarily. In some situations **NKRO** doesn't work and you will need to switch to **6KRO** mode, in particular when you are in BIOS.
If your firmware was built with `BOOTMAGIC_ENABLE` you need to turn its switch on by `BootMagic`**N** command(`Space+N` by default). This setting is stored in EEPROM and kept over power cycles.
@ -8,8 +8,6 @@ On some keyboards Bootmagic Lite is disabled by default. If this is the case, it
BOOTMAGIC_ENABLE = yes
```
?> You may see `lite` being used in place of `yes`.
Additionally, you may want to specify which key to use. This is especially useful for keyboards that have unusual matrices. To do so, you need to specify the row and column of the key that you want to use. Add these entries to your `config.h` file:
@ -85,10 +85,6 @@ Premièrement, vous devez compiler le firmware avec l'option de compilation `NKR
Essayez la commande `Magic`**N** (`LShift+RShift+N` par défaut) si **NKRO** ne fonctionne toujours pas. Vous pouvez utiliser cette commande pour basculer temporairement entre le mode **NKRO** et **6KRO**. Sous certaines conditions, **NKRO** ne fonctionnera pas et vous devrez basculer en **6KRO**, en particulier lorsque vous êtes dans le BIOS.
Si votre firmware est compilé avec `BOOTMAGIC_ENABLE` vous devrez l'activer avec la commande `BootMagic`**N** (`Espace+N` par défaut). Cette option est enregistrée dans l'EEPROM et sera gardé entre deux cycles de démarrage.
## Le TrackPoint a besoin Circuit de réinitialisation (Support de souris PS/2)
Sans circuit de réinitialisation vous allez avoir des résultats inconsistants à cause de la mauvaise initialisation du matériel. Regardez le schéma du circuit du TPM754.
@ -55,7 +55,7 @@ Set these variables to `no` to disable them, and `yes` to enable them.
`BOOTMAGIC_ENABLE`
This allows you to hold a key and the salt key (space by default) and have access to a various EEPROM settings that persist over power loss. It's advised you keep this disabled, as the settings are often changed by accident, and produce confusing results that makes it difficult to debug. It's one of the more common problems encountered in help sessions.
This allows you to hold a key (usually Escape by default) to reset the EEPROM settings that persist over power loss and ready your keyboard to accept new firmware.