You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
Ryan 4791cfae1a
Remove width, height and key_count from info.json (#14274)
2 years ago
..
keymaps Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2 years ago
rev_a Remove Full Bootmagic (#13846) 2 years ago
info.json Remove width, height and key_count from info.json (#14274) 2 years ago
readme.md Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2 years ago

readme.md

Viper/Eagle REP Rev A

A alternative PCB for Viper and Eagle V2 and V3

  • Keyboard Maintainer: 4pplet
  • Hardware Supported: Viper/Eagle REP Rev A

Make example for this keyboard (after setting up your build environment):

make 4pplet/eagle_viper_rep/rev_a:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

How to enter bootloader (DFU):

  • Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
  • Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.

Alternative option if the firmware is already pre-flashed:

  • Unplug your keyboard, hold down the Spacebar and B at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.