You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
Ryan 5bd68e3695
Move single `LAYOUT`s to data driven (#20365)
1 year ago
..
keymaps/default Remove legacy keycodes, part 6 (#18740) 1 year ago
rev1 Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 1 year ago
rev2 Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 1 year ago
config.h Migrate `rgblight.pin` and `RGB_DI_PIN` to `ws2812.pin` (#20303) 1 year ago
halconf.h Keyboard/grandiceps (#11933) 3 years ago
info.json Move single `LAYOUT`s to data driven (#20365) 1 year ago
mcuconf.h Keyboard/grandiceps (#11933) 3 years ago
readme.md RESET -> QK_BOOT keyboard readme (#18110) 1 year ago
rules.mk Move `WS2812_DRIVER` to data driven (#20248) 1 year ago

readme.md

grandiceps

grandiceps

ARM split keyboard with RGB underglow and encoders.

  • Keyboard Maintainer: vattern
  • Hardware Supported: f411 blackpill
  • Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

  • Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available